Tools you may need:
• Tape measure: For measuring large
areas for body graphics and hood
graphics.
• Ruler: For measuring small areas for
decal placement.
Most of our measurements go by width. Some people
confuse this with height. To help clear this up, and so
that there are no mix-ups, the width measurement is the same as length (left to right). The height is from the top to bottom. Most of
our ordering pages require a width/length measurement,
please remember to measure width/length <-left to right->.
Other product pages may require a height measurement. The height is the measurement from the highest point to the lowest
point, from top to bottom.
Examine the graphic in the photo. Make note of where it begins
at the front of the vehicle
and where it ends at the rear of the vehicle. These 2 points will be
where you measure from and to on your vehicle. The length you
come up with will be
required when ordering, NOT the vehicles length. We do not need
height measurements, as it will be proportion with the selected
length.
Note: You can order graphics to be smaller or larger
than
the designs seen in the photos. Trimming of the
graphic may be required.
Use your own judgment to choose what length will work for
you.
Bring a tape measure to your vehicle and measure the hood
where you would like the graphic to be applied.
With a measuring tape, measure the total
length
of stripes needed to cover front bumper, hood, roof, trunk
and rear. Only measure the areas you plan to put stripes
on.
Its always smart to order a little extra in length.
Visor strips:
From the top center of the windshield, measure down 6-7
inches. At that point, measure the windshield from left to right. This
will be the measurement you submit when placing your order.
Lettering / logos:
From the top center of the windshield, measure down 6-7
inches. Then measure left to right to determine the width you want
the windshield decal to be. Be sure to leave at least a 2-3 inches
on each side.
For T-Shirt/Pullover size help Click
Here
Click Here
|
